Re: (no subject)

Hi Joshua,

On 30/06/16 21:52, Joshua Stokes wrote:
> My question is about compiling uclinux-rootfs, specifically the 1st step in the README file which reads:
> 
> You will need a cross-compiler package for your target. Many binary
>      tools packages exists specifically for compiling uClinux. Install
>      that in the standard way first. For example, if you are targeting m68k
>      or ColdFire systems then you can use the m68k-elf-tools binary
>      packages of www.uclinux.org.

Specifically on the question of cross compilers, there is some
binary toolchains on the uclinux sourceforge site:

https://sourceforge.net/projects/uclinux/files/Tools/

Regards
Greg


> I am basically trying to compile a uclinux distribution that is installed on STBs, specifically the Fetch TV uclinux. The firmware version is 2.01278 and the required files are located at http://www.fetchtv.com.au/opensource
> 
> Can someone please shed some light on this situation
> 
> Thanks
> 
>>From Joshua P Stokes
> _______________________________________________
> uClinux-dev mailing list
> [email protected]
> http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
> This message was resent by [email protected]
> To unsubscribe see:
> http://mailman.uclinux.org/mailman/options/uclinux-dev
> 

_______________________________________________
uClinux-dev mailing list
[email protected]
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by [email protected]
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev