[PATCH 16/17] riscv: use the correct interrupt levels for M-mode

The numerical levels for External/Timer/Software interrupts differ
between S-mode and M-mode.

Signed-off-by: Christoph Hellwig <[email protected]>
---
 arch/riscv/kernel/irq.c | 12 +++++++++---
 1 file changed, 9 insertions(+), 3 deletions(-)

diff --git a/arch/riscv/kernel/irq.c b/arch/riscv/kernel/irq.c
index 804ff70bb853..9566aabbe50b 100644
--- a/arch/riscv/kernel/irq.c
+++ b/arch/riscv/kernel/irq.c
@@ -14,9 +14,15 @@
 /*
  * Possible interrupt causes:
  */
-#define INTERRUPT_CAUSE_SOFTWARE	IRQ_S_SOFT
-#define INTERRUPT_CAUSE_TIMER		IRQ_S_TIMER
-#define INTERRUPT_CAUSE_EXTERNAL	IRQ_S_EXT
+#ifdef CONFIG_M_MODE
+# define INTERRUPT_CAUSE_SOFTWARE	IRQ_M_SOFT
+# define INTERRUPT_CAUSE_TIMER		IRQ_M_TIMER
+# define INTERRUPT_CAUSE_EXTERNAL	IRQ_M_EXT
+#else
+# define INTERRUPT_CAUSE_SOFTWARE	IRQ_S_SOFT
+# define INTERRUPT_CAUSE_TIMER		IRQ_S_TIMER
+# define INTERRUPT_CAUSE_EXTERNAL	IRQ_S_EXT
+#endif /* CONFIG_M_MODE */
 
 int arch_show_interrupts(struct seq_file *p, int prec)
 {
-- 
2.20.1