Re: Fw: [Bugme-new] [Bug 8104] New: kernel floods console with "connect-debounce failed"
Alan Stern <[email protected]>
| Newsgroups | gmane.linux.usb.devel |
|---|---|
| Message-ID | <[email protected]> |
On Sun, 4 Mar 2007, Oliver Neukum wrote: > > I noticed that the message occurs if the device is active BEFORE > > uhci-hcd gets loaded. > > e.g. > > > > boot with bluetooth on: debounce failed > > switch off/on bluetooth: device recognized and working > > rmmod uhci-hcd then modprobe uhci-hcd: debounce failed again > > > > and of course > > boot with bt off then switching on: device recognized and working > > rmmod uhci-hcd then modprobe uhci-hcd: debounce failed > > This makes it likely that some device initialisation code is not severe > enough. It is important to find out why one kernel works and the other > does not. On the contrary, this indicates the problem has nothing to do with the kernel version at all. Probably it's just an accident of timing that one system ends up loading uhci-hcd before the device is active and other systems don't. There was a very similar report recently involving ohci-hcd. Evidently some EHCI controllers won't perform a handoff if the companion controller isn't initialized. Alan Stern ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys-and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ [email protected] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel