Re: Problem with Sony USB card reader

Can you use fdisk to read the partition table of the card in either case?

Matt

On Wed, Apr 11, 2007 at 10:00:33PM +0100, [email protected] wrote:
> I have a VGP-MCA20 Memory Card Adapter that fits in the ExpressCard slot
> of a Vaio SZ3.  When I insert a 1GB SD card into the adapter, it is not
> detected correctly, whereas it does work in a Shuttle card reader
> attached to an SN41G.
> 
> Here are the messages when the adapter is inserted:
> 
> usb 5-4: new high speed USB device using ehci_hcd and address 6
> usb 5-4: configuration #1 chosen from 1 choice
> scsi3 : SCSI emulation for USB Mass Storage devices
> usb-storage: device found at 6
> usb-storage: waiting for device to settle before scanning
> scsi 3:0:0:0: Direct-Access     Sony     USB   HS-CARD    4.52 PQ: 0
> ANSI: 0
> sd 3:0:0:0: Attached scsi removable disk sdb
> sd 3:0:0:0: Attached scsi generic sg1 type 0
> usb-storage: device scan complete
> 
> /sbin/lspci:
> 
> 00:00.0 Host bridge: Intel Corporation Mobile 945GM/PM/GMS/940GML and
> 945GT Express Memory Controller Hub (rev 03)
> 00:02.0 VGA compatible controller: Intel Corporation Mobile
> 945GM/GMS/940GML Express Integrated Graphics Controller (rev 03)
> 00:02.1 Display controller: Intel Corporation Mobile 945GM/GMS/940GML
> Express Integrated Graphics Controller (rev 03)
> 00:1b.0 Audio device: Intel Corporation 82801G (ICH7 Family) High
> Definition Audio Controller (rev 02)
> 00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express
> Port 1 (rev 02)
> 00:1c.1 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express
> Port 2 (rev 02)
> 00:1c.2 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express
> Port 3 (rev 02)
> 00:1c.3 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express
> Port 4 (rev 02)
> 00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI
> #1 (rev 02)
> 00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI
> #2 (rev 02)
> 00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI
> #3 (rev 02)
> 00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI
> #4 (rev 02)
> 00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI
> Controller (rev 02)
> 00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev e2)
> 00:1f.0 ISA bridge: Intel Corporation 82801GBM (ICH7-M) LPC Interface
> Bridge (rev 02)
> 00:1f.1 IDE interface: Intel Corporation 82801G (ICH7 Family) IDE
> Controller (rev 02)
> 00:1f.2 IDE interface: Intel Corporation 82801GBM/GHM (ICH7 Family)
> Serial ATA Storage Controller IDE (rev 02)
> 00:1f.3 SMBus: Intel Corporation 82801G (ICH7 Family) SMBus Controller
> (rev 02)
> 06:00.0 Network controller: Intel Corporation PRO/Wireless 3945ABG
> Network Connection (rev 02)
> 07:00.0 Ethernet controller: Marvell Technology Group Ltd. 88E8036 PCI-E
> Fast Ethernet Controller (rev 15)
> 09:04.0 CardBus bridge: Texas Instruments PCIxx12 Cardbus Controller
> 09:04.1 FireWire (IEEE 1394): Texas Instruments PCIxx12 OHCI Compliant
> IEEE 1394 Host Controller
> 09:04.2 Mass storage controller: Texas Instruments 5-in-1 Multimedia
> Card Reader (SD/MMC/MS/MS PRO/xD)
> 
> /sbin/lsusb:
> 
> Bus 001 Device 001: ID 0000:0000  
> Bus 003 Device 001: ID 0000:0000  
> Bus 003 Device 002: ID 0483:2016 SGS Thomson Microelectronics
> Fingerprint Reader
> Bus 005 Device 006: ID 054c:0281 Sony Corp. 
> Bus 005 Device 001: ID 0000:0000  
> Bus 005 Device 004: ID 05ca:1830 Ricoh Co., Ltd 
> Bus 004 Device 002: ID 044e:300c Alps Electric Co., Ltd 
> Bus 004 Device 001: ID 0000:0000  
> Bus 002 Device 001: ID 0000:0000  
> 
> These are the messages when the SD card is inserted:
> 
> Apr  9 23:21:04 morel kernel: SCSI device sdb: 1984000 512-byte hdwr
> sectors (1016 MB)
> Apr  9 23:21:04 morel kernel: sdb: Write Protect is off
> Apr  9 23:21:04 morel kernel: sdb: assuming drive cache: write through
> Apr  9 23:21:04 morel kernel: SCSI device sdb: 1984000 512-byte hdwr
> sectors (1016 MB)
> Apr  9 23:21:04 morel kernel: sdb: Write Protect is off
> Apr  9 23:21:04 morel kernel: sdb: assuming drive cache: write through
> Apr  9 23:21:10 morel kernel:  sdb:<6>sdb: Current: sense key: No Sense
> Apr  9 23:21:10 morel kernel:     Additional sense: No additional sense
> information
> Apr  9 23:21:16 morel kernel: sdb: Current: sense key: No Sense
> Apr  9 23:21:16 morel kernel:     Additional sense: No additional sense
> information
> Apr  9 23:21:16 morel kernel:  unknown partition table
> Apr  9 23:21:22 morel kernel: sdb: Current: sense key: No Sense
> Apr  9 23:21:22 morel kernel:     Additional sense: No additional sense
> information
> Apr  9 23:21:28 morel kernel: sdb: Current: sense key: No Sense
> Apr  9 23:21:28 morel kernel:     Additional sense: No additional sense
> information
> 
> 
> Adam

-- 
Matthew Dharm                              Home: [email protected] 
Maintainer, Linux USB Mass Storage Driver

S:  Another stupid question?
G:  There's no such thing as a stupid question, only stupid people.
					-- Stef and Greg
User Friendly, 7/15/1998

-------------------------------------------------------------------------
Take Surveys. Earn Cash. Influence the Future of IT
Join SourceForge.net's Techsay panel and you'll get the chance to share your
opinions on IT & business topics through brief surveys-and earn cash
http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV

_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.7 (GNU/Linux)

iD8DBQFGHWGWHL9iwnUZqnkRAtQDAJ9EAWQUyCmaEnVwAXyg1TWViH64oQCgmVyl
qUOgo/tKpSv0rgBxvlfvops=
=u+vU
-----END PGP SIGNATURE-----