Re: [PATCH] Fix NEC OHCI chip silicon bug

On Mon, 4 Jun 2007, Michael Hanselmann wrote:

> On Sat, Jun 02, 2007 at 10:49:44AM -0400, Alan Stern wrote:
> > Then later on, when the hub driver is resumed it will see the flag and
> > disconnect all the devices below the root hub.
> 
> > For instance, you could force ohci-hcd to report connect-change events
> > on all the ports. Perhaps it does something like that anyway, in which
> > case you wouldn't have to worry about it.
> 
> After studying the code for two evenings, I'm quite sure it does that
> already.
> 
> A comment in ohci-hcd.c:ohci_restart reads:
>   /* mark any devices gone, so they do nothing till khubd disconnects.
>    * recycle any "live" eds/tds (and urbs) right away.
>    * later, khubd disconnect processing will recycle the other state,
>    * (either as disconnect/reconnect, or maybe someday as a reset).
>    */

Don't believe everything you read in comments.  That one is very out of 
date.  It should be removed.

> usb_root_hub_lost_power marks the ports as gone, khubd will disconnect them.

Wrong.  usb_root_hub_lost_power does _not_ mark the ports as gone, and 
it does _not_ tell khubd to disconnect them.  (Depending on which 
version of the kernel you are looking at -- I'm referring to the latest 
development kernel including the gregkh-all patch set.  Earlier 
versions did behave the way you describe.)

> After restarting the chip, khubd will cause them to be detected again.
> 
> This is also what I can watch in the logs:
>   ohci_hcd 0001:10:15.1: OHCI Unrecoverable Error, scheduling NEC chip restart
>   usb usb2: root hub lost power or was reset
>   usb 2-2: USB disconnect, address 2
>   input: appletouch disconnected
>   usb 2-2: new full speed USB device using ohci_hcd and address 3
>   usb 2-2: configuration #1 chosen from 1 choice
>   input: Apple Computer Apple Internal Keyboard / Trackpad as /class/input/input16 on usb-0001:10:15.1-2
>   input: appletouch as /class/input/input17
>   input: Apple Computer Apple Internal Keyboard / Trackpad as /class/input/input18 on usb-0001:10:15.1-2
> 
> (Actually, I added some code to trigger the error handling code, reliably
> reproducing it otherwise is impossible.)

So the system is behaving the way you want, but not for the reason you 
think.  I bet you could remove the call to usb_root_hub_lost_power() 
entirely and it wouldn't make any difference at all.

Alan stern


-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel