Re: Kconfig troubles when using menuconfig - Was: [patch]Re: linux-2.6.22-rc5-gf1518a0 build #300 failed in zc0301_core.c

Hi,

On Fri, 22 Jun 2007, Mauro Carvalho Chehab wrote:

> Hi Roman,
> 
> Several instabilities on Kconfig started to happen after replacing
> Kconfig menus to use menuconfig, as this one, reported by Oliver:
> 
> Em Qui, 2007-06-21 às 13:50 +0200, Oliver Neukum escreveu:
> > Am Donnerstag, 21. Juni 2007 schrieb Toralf Förster:
> > > Right, but IMHO this issue is typical for a problem with the Kconfig definitions of this module.
> > > 
> > > I'll set USB devs as Cc: therefore.

There is too little context here, what was the exact error?
I'm assuming it's the module vs. builtin problem?

> In this specific case, all V4L USB drivers depends on V4L_USB_DRIVERS,
> that depends, in turn, on USB. So, if USB is not selected,
> V4L_USB_DRIVERS should be unselected, unselecting zc0301.
> 
> Unfortunately, the Kernel building system is not properly handling it.
> 
> This is the (snipped) media/video/Kconfig:
> 
> menuconfig V4L_USB_DRIVERS
>         bool "V4L USB devices"
>         depends on USB
>         default y
> 

The menuconfig patches were a little aggressive here, it created a config 
symbol where there was none before and in this case it even changed 
dependencies (it turns USB into a bool).
I'm also a little irritated by the "default y", if I enable V4L I'm very 
tempted to check what other useless stuff has been automatically enabled, 
which I have to turn off again.

bye, Roman

-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/

_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel