Re: High speed devices with kernel 2.6.21.5.

On 6/29/07, Branden Sletteland <[email protected]> wrote:
> I am seeing an issue when going from kernel version 2.6.20.14 to
> 2.6.21 through 2.6.21.5 were my high speed devices are only being
> recognized as full speed devices, with error output on a 2.6.21 kernel
> stating:
>
> usb 3-1: new full speed USB device using ohci_hcd and address 11
> usb 3-1: not running at top speed; connect to a high speed hub
> usb 3-1: configuration #1 chosen from 1 choice
>
> I'm using a Philips (NXP) ISP1563 PCI based host controller
> (OHCI/EHCI) and my high speed mass storage devices are Cypress EZ-USB
> FX2LP CY7C68013A devices with compact flash interfaces.
>
> This hardware setup is rock solid when running with a 2.6.20.14
> kernel, I have never seen the devices initialize as full speed USB
> devices with this and earlier versions of 2.6.20.

I see there is
"Bus 003 Device 011: ID 127a:6830"
in the output of lsusb -v against 2.6.21.5 kernel.
But this information didn't show in the output of 2.6.20.14.
Please can you also paste it too.

-------------------------------------------------------------------------
This SF.net email is sponsored by DB2 Express
Download DB2 Express C - the FREE version of DB2 express and take
control of your XML. No limits. Just data. Click to get it now.
http://sourceforge.net/powerbar/db2/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel