[PATCH 024/149] USB: EHCI: fix handover for designated full-speed ports
Greg Kroah-Hartman <[email protected]>
| Newsgroups | gmane.linux.usb.devel |
|---|---|
| Message-ID | <[email protected]> |
From: Alan Stern <[email protected]> This patch (as895) fixes up a loose end in the port-handover code for the USB-Persist facility. A special case occurs when a high-speed device is attached to a port which the user has designated to run at full-speed only; the port must be disabled before the handover can take place. Signed-off-by: Alan Stern <[email protected]> Signed-off-by: Greg Kroah-Hartman <[email protected]> --- drivers/usb/host/ehci-hub.c | 4 +++- 1 files changed, 3 insertions(+), 1 deletions(-) diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c index 3e80de7..27291f5 100644 --- a/drivers/usb/host/ehci-hub.c +++ b/drivers/usb/host/ehci-hub.c @@ -60,11 +60,13 @@ static void ehci_handover_companion_ports(struct ehci_hcd *ehci) while (port--) { if (test_bit(port, &ehci->owned_ports)) { reg = &ehci->regs->port_status[port]; - status = ehci_readl(ehci, reg); + status = ehci_readl(ehci, reg) & ~PORT_RWC_BITS; /* Port already owned by companion? */ if (status & PORT_OWNER) clear_bit(port, &ehci->owned_ports); + else if (test_bit(port, &ehci->companion_ports)) + ehci_writel(ehci, status & ~PORT_PE, reg); else ehci_hub_control(hcd, SetPortFeature, USB_PORT_FEAT_RESET, port + 1, -- 1.5.2.2 ------------------------------------------------------------------------- This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ [email protected] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel