Re: [Bugme-new] [Bug 8792] New: kernel incorrectly initialises mass storage component of HUAWEI E220

On Sun, 22 Jul 2007 17:16:13 -0700 (PDT) [email protected] wrote:

> http://bugzilla.kernel.org/show_bug.cgi?id=8792
> 
>            Summary: kernel incorrectly initialises mass storage component of
>                     HUAWEI E220
>            Product: IO/Storage
>            Version: 2.5
>      KernelVersion: 2.6.22
>           Platform: All
>         OS/Version: Linux
>               Tree: Mainline
>             Status: NEW
>           Severity: normal
>           Priority: P1
>          Component: SCSI
>         AssignedTo: [email protected]
>         ReportedBy: [email protected]
>                 CC: [email protected]
> 
> 
> Most recent kernel where this bug did not occur: vanilla 2.6.22

I think this was supposed to be "not known"..  It is unclear.

> Distribution: Slackware 12.0
> Hardware Environment: HUAWEI USB modem E220 on Intel 82801G (ICH7) USB2 EHCI;
> Intel 82801G (ICH7) PCI Express
> Software Environment: SCSI
> Problem Description: The HUAWEI USB modem includes a mass storage device to
> access the modem's built-in ROM. The kernel's SCSI environment (see relevant
> dmesg below) incorrectly initializes that mass storage device as a CDROM on
> /dev/sr1, which causes three known symptoms:
> 
> 1) "/etc/rc.d/rc.hald start" removes /dev/sr1 until udev puts it back. This
> means that the modem gets initialized twice every time I boot Linux.
> Workarounds: (i) do not start hald, or (ii) attach the modem after hald has
> initialized.
> 
> 2) k3b device scan also removes /dev/sr1 and if I am unlucky and have pppd
> already running, pppd gets terminated as well. Workaround: "chmod 000 /dev/sr1"
> or "chgrp root /dev/sr1" (Slackware udev initializes /dev/sr1 as group cdrom).
> 
> 3) Warnings from module "option":
> dmesg | grep -i option
> option: Unknown symbol usb_serial_port_softint
> option: Unknown symbol usb_serial_disconnect
> option: Unknown symbol usb_serial_probe
> option: Unknown symbol usb_serial_register
> option: Unknown symbol usb_serial_deregister
> option 3-1:1.0: GSM modem (1-port) converter detected
> option 3-1:1.1: GSM modem (1-port) converter detected
> usbcore: registered new interface driver option
> drivers/usb/serial/option.c: USB Driver for GSM modems: v0.7.1
> 
> Other relevant information:
> dmesg | grep -i scsi
> SCSI subsystem initialized
> scsi0 : ata_piix
> scsi1 : ata_piix
> scsi 0:0:0:0: Direct-Access     ATA      TOSHIBA MK1637GS DL03 PQ: 0 ANSI: 5
> sd 0:0:0:0: [sda] Attached SCSI disk
> scsi 1:0:0:0: CD-ROM            HL-DT-ST DVDRAM GSA-T20N  WT03 PQ: 0 ANSI: 5
> sr0: scsi3-mmc drive: 24x/24x writer dvd-ram cd/rw xa/form2 cdda tray
> sr 1:0:0:0: Attached scsi CD-ROM sr0
> scsi2 : SCSI emulation for USB Mass Storage devices
> scsi 2:0:0:0: CD-ROM            HUAWEI   Mass Storage     2.31 PQ: 0 ANSI: 2
> sr1: scsi3-mmc drive: 0x/0x caddy
> sr 2:0:0:0: Attached scsi CD-ROM sr1
> 
> LUN scan shows HUAWEI as type "cdrom" again:
> /etc/rc.d/rc.scanluns
> Scanning all LUNs for additional hardware:  /sbin/rescan-scsi-bus -l
> Host adapter 0 (ata_piix) found.
> Host adapter 1 (ata_piix) found.
> Host adapter 2 (usb-storage) found.
> Scanning hosts  0 1 2 channels 0 for
>  SCSI target IDs  0 1 2 3 4 5 6 7 , LUNs  0 1 2 3 4 5 6 7
> Scanning for device 0 0 0 0 ...
> OLD: Host: scsi0 Channel: 00 Id: 00 Lun: 00
>       Vendor: ATA      Model: TOSHIBA MK1637GS Rev: DL03
>       Type:   Direct-Access                    ANSI SCSI revision: 05
> Scanning for device 1 0 0 0 ...
> OLD: Host: scsi1 Channel: 00 Id: 00 Lun: 00
>       Vendor: HL-DT-ST Model: DVDRAM GSA-T20N  Rev: WT03
>       Type:   CD-ROM                           ANSI SCSI revision: 05
> Scanning for device 2 0 0 0 ...
> OLD: Host: scsi2 Channel: 00 Id: 00 Lun: 00
>       Vendor: HUAWEI   Model: Mass Storage     Rev: 2.31
>       Type:   CD-ROM                           ANSI SCSI revision: 02
> 0 new device(s) found.
> 0 device(s) removed.
> 
> Modules:
> usb_storage            31812  0
> usbserial              25320  4 option
> soundcore               5792  1 snd
> uhci_hcd               19404  0
> ehci_hcd               26444  0
> 
> Steps to reproduce: reboot with modem connected
> 
> 
> -- 
> Configure bugmail: http://bugzilla.kernel.org/userprefs.cgi?tab=email
> ------- You are receiving this mail because: -------
> You are on the CC list for the bug, or are watching someone who is.

-------------------------------------------------------------------------
This SF.net email is sponsored by: Splunk Inc.
Still grepping through log files to find problems?  Stop.
Now Search log events and configuration files using AJAX and a browser.
Download your FREE copy of Splunk now >>  http://get.splunk.com/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel