[2.6.22.2 review 22/84] usb-serial: Fix edgeport regression on non-EPiC devices

From: Adam Kropelin <[email protected]>

Fix serious regression on non-EPiC edgeport usb-serial devices. Baud
rate and MCR/LCR registers are not being written on these models due
to apparent copy-n-paste errors introduced with EPiC support.

Failure reported by Nick Pasich <[email protected]>.

Signed-off-by: Adam Kropelin <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>

---
 drivers/usb/serial/io_edgeport.c |   19 ++++++++-----------
 1 file changed, 8 insertions(+), 11 deletions(-)

--- a/drivers/usb/serial/io_edgeport.c
+++ b/drivers/usb/serial/io_edgeport.c
@@ -2366,9 +2366,8 @@ static int send_cmd_write_baud_rate (str
 	int status;
 	unsigned char number = edge_port->port->number - edge_port->port->serial->minor;
 
-	if ((!edge_serial->is_epic) ||
-	    ((edge_serial->is_epic) &&
-	     (!edge_serial->epic_descriptor.Supports.IOSPSetBaudRate))) {
+	if (edge_serial->is_epic &&
+	    !edge_serial->epic_descriptor.Supports.IOSPSetBaudRate) {
 		dbg("SendCmdWriteBaudRate - NOT Setting baud rate for port = %d, baud = %d",
 		    edge_port->port->number, baudRate);
 		return 0;
@@ -2461,18 +2460,16 @@ static int send_cmd_write_uart_register 
 
 	dbg("%s - write to %s register 0x%02x", (regNum == MCR) ? "MCR" : "LCR", __FUNCTION__, regValue);
 
-	if ((!edge_serial->is_epic) ||
-	    ((edge_serial->is_epic) &&
-	     (!edge_serial->epic_descriptor.Supports.IOSPWriteMCR) &&
-	     (regNum == MCR))) {
+	if (edge_serial->is_epic &&
+	    !edge_serial->epic_descriptor.Supports.IOSPWriteMCR &&
+	    regNum == MCR) {
 		dbg("SendCmdWriteUartReg - Not writing to MCR Register");
 		return 0;
 	}
 
-	if ((!edge_serial->is_epic) ||
-	    ((edge_serial->is_epic) &&
-	     (!edge_serial->epic_descriptor.Supports.IOSPWriteLCR) &&
-	     (regNum == LCR))) {
+	if (edge_serial->is_epic &&
+	    !edge_serial->epic_descriptor.Supports.IOSPWriteLCR &&
+	    regNum == LCR) {
 		dbg ("SendCmdWriteUartReg - Not writing to LCR Register");
 		return 0;
 	}

--