Re: 2.6.23-rc6: usb 1-1: device not accepting address 2, error -62

On Sat, 15 Sep 2007 03:48:19 -0700, Andrew Morton <[email protected]> wrote:

> > I have an error message with 2.6.23-rc6.
> > This did not happen with 2.6.22.
> 
> Another one for Michal's dirt file.

No, I think it's the module ordering again.

> > 2.6.23-rc6 boot.msg extract ( hub/usb )

I wish users stopped this filtering, it's a very bad idea.

As it is, there's no message showing when ehci_hcd was loaded.
We can try piece together the picture:

> > <6>usb usb1: configuration #1 chosen from 1 choice
> > <6>hub 1-0:1.0: USB hub found
> > <6>hub 1-0:1.0: 2 ports detected
> > <6>usb usb2: configuration #1 chosen from 1 choice
> > <6>hub 2-0:1.0: USB hub found
> > <6>hub 2-0:1.0: 2 ports detected
> > <6>usb 1-1: new low speed USB device using ohci_hcd and address 2

ok this was ohci_hcd

> > <3>usb 1-1: device not accepting address 2, error -62
> > <6>usb 5-2: new full speed USB device using uhci_hcd and address 2

was ehci here? We don't know but I bet it was, because:

> > <6>usb 6-2: new high speed USB device using ehci_hcd and address 2

> > 2.6.22 boot.msg extract ( hub/usb )

This one seems far shorter. The EHCI comes online late here as well,
but not as late as in the "regression" case. I am wondering if we
have some kind of "parallel PCI probing" option in action here.

-- Pete