Re: 2.6.23-rc6: usb 1-1: device not accepting address 2, error -62

Christian Volkmann <[email protected]>
Newsgroups gmane.linux.usb.devel,gmane.linux.kernel
Message-ID <[email protected]>
Pete Zaitcev wrote:
> On Sat, 15 Sep 2007 03:48:19 -0700, Andrew Morton <[email protected]> wrote:
> 
>>> I have an error message with 2.6.23-rc6.
>>> This did not happen with 2.6.22.
>> Another one for Michal's dirt file.
> 
> No, I think it's the module ordering again.
> 
>>> 2.6.23-rc6 boot.msg extract ( hub/usb )
> 
> I wish users stopped this filtering, it's a very bad idea.
> 
Sorry about this. I want to keep the postings shorter.
Please see my earlier reply for the complete messages made
with CONFIG_PRINTK_TIME and CONFIG_USB_DEBUG

> As it is, there's no message showing when ehci_hcd was loaded.
> We can try piece together the picture:
> 
>>> <6>usb usb1: configuration #1 chosen from 1 choice
>>> <6>hub 1-0:1.0: USB hub found
>>> <6>hub 1-0:1.0: 2 ports detected
>>> <6>usb usb2: configuration #1 chosen from 1 choice
>>> <6>hub 2-0:1.0: USB hub found
>>> <6>hub 2-0:1.0: 2 ports detected
>>> <6>usb 1-1: new low speed USB device using ohci_hcd and address 2
> 
> ok this was ohci_hcd
> 
>>> <3>usb 1-1: device not accepting address 2, error -62
>>> <6>usb 5-2: new full speed USB device using uhci_hcd and address 2
> 
> was ehci here? We don't know but I bet it was, because:
> 
>>> <6>usb 6-2: new high speed USB device using ehci_hcd and address 2
> 
>>> 2.6.22 boot.msg extract ( hub/usb )
> 
> This one seems far shorter. The EHCI comes online late here as well,
> but not as late as in the "regression" case. I am wondering if we
> have some kind of "parallel PCI probing" option in action here.

I can send my .config on request.

The system itself is a regular suse 10.2.


> 
> -- Pete
> 

Christian

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.