status_ep in ether.c

Hi guys, sorry if this is kind of a noob question, but exactly what ep 
should the status_ep autoconfig to?

for example, heres the memory struct from lh7a40x_udc:

static struct lh7a40x_udc memory = {
    .usb_address = 0,

    .gadget = {
           .ops = &lh7a40x_udc_ops,
           .ep0 = &memory.ep[0].ep,
           .name = driver_name,
           .dev = {
               .bus_id = "gadget",
               .release = nop_release,
               },
           },

    /* control endpoint */
    .ep[0] = {
          .ep = {
             .name = ep0name,
             .ops = &lh7a40x_ep_ops,
             .maxpacket = EP0_PACKETSIZE,
             },
          .dev = &memory,

          .bEndpointAddress = 0,
          .bmAttributes = 0,

          .ep_type = ep_control,
          .fifo = io_p2v(USB_EP0_FIFO),
          .csr1 = USB_EP0_CSR,
          .csr2 = USB_EP0_CSR,
          },

    /* first group of endpoints */
    .ep[1] = {
          .ep = {
             .name = "ep1in-bulk",
             .ops = &lh7a40x_ep_ops,
             .maxpacket = 64,
             },
          .dev = &memory,

          .bEndpointAddress = USB_DIR_IN | 1,
          .bmAttributes = USB_ENDPOINT_XFER_BULK,

          .ep_type = ep_bulk_in,
          .fifo = io_p2v(USB_EP1_FIFO),
          .csr1 = USB_IN_CSR1,
          .csr2 = USB_IN_CSR2,
          },

    .ep[2] = {
          .ep = {
             .name = "ep2out-bulk",
             .ops = &lh7a40x_ep_ops,
             .maxpacket = 64,
             },
          .dev = &memory,

          .bEndpointAddress = 2,
          .bmAttributes = USB_ENDPOINT_XFER_BULK,

          .ep_type = ep_bulk_out,
          .fifo = io_p2v(USB_EP2_FIFO),
          .csr1 = USB_OUT_CSR1,
          .csr2 = USB_OUT_CSR2,
          },

    .ep[3] = {
          .ep = {
             .name = "ep3in-int",
             .ops = &lh7a40x_ep_ops,
             .maxpacket = 64,
             },
          .dev = &memory,

          .bEndpointAddress = USB_DIR_IN | 3,
          .bmAttributes = USB_ENDPOINT_XFER_INT,

          .ep_type = ep_interrupt,
          .fifo = io_p2v(USB_EP3_FIFO),
          .csr1 = USB_IN_CSR1,
          .csr2 = USB_IN_CSR2,
          },
};

Should status_ep autoconfig to ep0?

Thanks for any input guys.

best,
Lorenzo

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel