Re: How to enable both CDC and RNDIS support in same USB code

I am talking about ether.c file.I observed that few parts of the code
are specific to RNDIS or CDC under the flags CONFIG_USB_ETH_RNDIS and
DEV_CONFIG_CDC .
Please clarify me if I m wrong.

Thanks & Regards,
Imran
On Tue, 2007-09-25 at 13:12 +0200, Oliver Neukum wrote:
> Am Dienstag 25 September 2007 schrieb Imran Khan:
> > Hi Oliver,
> >  thanks a lot for your reply .Its not that windows not work with CDC
> > device,as far as I know windows use RNDIS standard for such
> > communication while Linux uses CDC standard and for these requirements I
> > observed that in 2.4 kernel we have to specify different flags before
> > building the kernel.
> 
> Are you sure that you are not talking about the gadget code?
> 
> 	Regards
> 		Oliver
> 
> 


-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel