Does Linux support more than 2TB on a USB attached device?

Hi,

I hope that this is not an oft repeated question, but recently during
testing we encountered the following errors:

Oct  2 18:43:12 red-gemini mail-notification: No worthy mechs found
Oct  2 18:45:55 red-gemini kernel: sd 7:0:0:0: [sdb] Very big device.
Trying
to use READ CAPACITY(16).
Oct  2 18:45:55 red-gemini kernel: sd 7:0:0:0: [sdb] READ CAPACITY(16)
failed
Oct  2 18:45:55 red-gemini kernel: sd 7:0:0:0: [sdb] Result:
hostbyte=DID_ABORT driverbyte=DRIVER_OK,SUGGEST_OK
Oct  2 18:45:55 red-gemini kernel: sd 7:0:0:0: [sdb] Use 0xffffffff as
device size
Oct  2 18:45:55 red-gemini kernel: sd 7:0:0:0: [sdb] 4294967296 512-byte
hardware sectors (2199023 MB)
Oct  2 18:45:55 red-gemini kernel: sd 7:0:0:0: [sdb] Write Protect is
off
Oct  2 18:45:55 red-gemini kernel: sd 7:0:0:0: [sdb] Assuming drive
cache:
write through
Oct  2 18:45:55 red-gemini kernel:  sdb:

I think we were returning 0x67FFFFFFF as the max LAB in the READ
CAPACITY(16).

Is there something special we need to enable in Linux to allow for more
than 2TB on a USB device?

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel