Re: [RESEND]: RNDIS host: adjust MTU instead of refusing to talk to devices with MTU < 1.5k

On Tue, 2007-10-09 at 08:18 -0700, David Brownell wrote:

> > This patch makes the host RNDIS driver talk to RNDIS devices with an MTU
> > less than 1.5k, instead of refusing to talk to such a device.
> > Please apply.
> >
> > Signed-Off-by: Thomas Sailer <[email protected]>
> 
> Acked-by: David Brownell <[email protected]>
> 
> ... but patches in drivers/net go to netdev, not linux-usb-devel.
> And it'd be nice if the patch comment mentioned some particular
> device that's been observed to act this way.

Ok, next try.

The device in question is a low power radio device that speaks the
bpqether protocol over ethernet. bpqether frames are never longer than
320 bytes, so there is no need to support 1.5kbyte MTU in the device
firmware.

Tom

Signed-Off-by: Thomas Sailer <[email protected]>

--- 1/drivers/net/usb/rndis_host.c.orig	2007-09-04 17:51:11.000000000 +0200
+++ 2/drivers/net/usb/rndis_host.c	2007-09-04 17:54:26.000000000 +0200
@@ -512,11 +512,18 @@
 	}
 	tmp = le32_to_cpu(u.init_c->max_transfer_size);
 	if (tmp < dev->hard_mtu) {
-		dev_err(&intf->dev,
-			"dev can't take %u byte packets (max %u)\n",
-			dev->hard_mtu, tmp);
-		retval = -EINVAL;
-		goto fail_and_release;
+		if (tmp <= net->hard_header_len) {
+			dev_warn(&intf->dev,
+				 "dev can't take %u byte packets (max %u)\n",
+				 net->hard_header_len+1, tmp);
+			retval = -EINVAL;
+			goto fail_and_release;
+		}
+		dev->hard_mtu = tmp;
+		net->mtu = dev->hard_mtu - net->hard_header_len;
+		dev_warn(&intf->dev,
+			 "dev can't take %u byte packets (max %u), adjusting MTU to %u\n",
+			 dev->hard_mtu, tmp, net->mtu);
 	}
 
 	/* REVISIT:  peripheral "alignment" request is ignored ... */



-------------------------------------------------------------------------
This SF.net email is sponsored by: Splunk Inc.
Still grepping through log files to find problems?  Stop.
Now Search log events and configuration files using AJAX and a browser.
Download your FREE copy of Splunk now >> http://get.splunk.com/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel