Multiple USB Endpoints

Hello,

I'm trying to work on integrating the barry usb phone driver but have
encountered a bit of a problem; when the usb_stoage module is loaded
and being used for one of the devices endpoints (the SD Card) the
libusb software (barry) can no longer talk to the phone.

>From what I understand the phone has 3 configurations with 2 devices
(serial and MSD) each with 1 end point. The usb_storage driver
connects to one of the end points but not the other, yet I'm at the
moment unsure of how to recode the driver to work with only th serial
endpoint and not expect to own the entire device via libusb.

Project details: To enabled phone device information to be stored in
HAL for use with syncing engines it must connect via the serial
interface after the power-control reset (bcharge/berry-charge) to find
out what the device id is, the description and the device pin and
store these details in HAL for every blackberry plugged in.

Apologies if I've sent this to the wrong list in error.

Best Regards, Martin Owens

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel