Re: MTP Protocol
Alan Stern <[email protected]>
| Newsgroups | gmane.linux.usb.devel |
|---|---|
| Message-ID | <[email protected]> |
On Thu, 22 Nov 2007, Ragner Magalhães wrote: > Hi all, > I bought a Creative Zen Vision:M 60G that use MTP protocol to > communicate with the PC. > When I plug it into USB port I get the follow messages: > -- > usb 4-5: new high speed USB device using ehci_hcd and address 5 > usb 4-5: configuration #1 chosen from 1 choice > usb 4-5: can't set config #1, error -110 > > -- > And my device does not work .... > > Anyone has an answer for this? Trade in your Creative Zen Vision:M for one that isn't broken. :-) Does it work on any other computers? Alan Stern ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ [email protected] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel