Re: query EHCI 3ms SUSPEND
"Pandita, Vikram" <[email protected]>
| Newsgroups | gmane.linux.usb.devel |
|---|---|
| Message-ID | <[email protected]> |
>From: David Brownell [mailto:[email protected]] ... >> If I check on Fedora, I don't see that happening rather SOFs keep going >> to the device? > >So far as software is concerned, once a port gets enabled it is >expected to issue SOFs unless it gets explicitly told to suspend. 1) So, Is it that from sysfs user interface on USB host we suspend the port (EHCI.PORTSC) so that devices see no activity on the bus and get suspended? 2) Please advise if the following is the right way to do a suspend of EHCI port with device enumerated: echo -n 2> /sys/devices/platform/ehci.0/usb1/1-2/1-2:1.0/power/state and I can see that SOFs have stopped from EHCI. Fine. I tried to resume the device with: echo -n 0> /sys/devices/platform/ehci.0/usb1/1-2/1-2:1.0/power/state and I see that device goes to Companion Controller and fails enumeration. What should be the correct behavior for Selective suspend/resume for the attached device? > > >- Dave ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ [email protected] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel