Re: blackberry 8830 problems - 2.6.23.10
Matt LaPlante <[email protected]>
| Newsgroups | gmane.linux.usb.devel |
|---|---|
| Message-ID | <[email protected]> |
On Sat, 15 Dec 2007 18:46:34 -0500 "Martin Owens" <[email protected]> wrote: > The device continues to reset it's self, disable bcharge or > berry_charge kernel module from udev/blacklist and try and find out > why bcharge fails to set the phone correctly. Sorry I have to plead a bit of ignorance here. I don't believe I'm using bcharge. I've got the berry_charge module built and loaded, which is the same as I used for the old blackberry. That's all I've needed in the past, so it's all I'm using now, and I had assumed it would support this device. I don't have any additional blackberry related software installed that I know of. Hence, I had assumed the problem was related to berry_charge, and I posted here. The usb cable is known working, and the port is a dedicated usb port with no other connected devices. As far as troubleshooting goes, I rebuilt with USB debugging support and tried again. I'll need guidance if I'm to gather additional information. The syslog output from connecting the device can be found here (much too long for pasting into email): http://www.cyberdogtech.com/download/pub/berry_charge_debug.txt > > On 15/12/2007, Matt LaPlante <[email protected]> wrote: > > I have a blackberry 8830 that I'm attempting to charge via USB with the 2.6.23.10 kernel. Unfortunately, when I plugged the device into the machine, all hell broke loose. In short, the load on the machine shot up, dmesg was full of usb & scsi messages, and udev was sucking cpu like there was no tomorrow. Here's the head and tail output from dmesg, snipped since it's a good several hundred lines in total: > > > > > > > > This machine is running Ubuntu Gutsy, udev version 113-0ubuntu16. As the phone is new, I believe this is the first time I've attempted to connect it to this machine. I used to connect my old blackberry without problems on the same hardware, but that was a slightly older kernel (2.6.22?). This behavior repeated across system reboots, and could only be solved by disconnecting the device. > > > > -- > > Matt LaPlante > > ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ [email protected] To unsubscribe, use the last form field at: https://lists.sourceforge.net/lists/listinfo/linux-usb-devel