Re: USB (GSM-)modems and ACM class driver

Hi,

even this issue is outstanding for about 8 weeks, I finally figured out a 
work around.

Our investment into a Catalyst USB analyzer has been worthwhile.
While comparing the traces between 2.4 and 2.6 kernels, I found out that
the 2.4 kernels send two 'set configuration' requests to the USB modem.

Either this is not allowed or the modem's firmware does not like this.
After the 2nd set configuration request the device disconnects.

As a workaround, I just commented out the usb_set_configuration() call in 
acm.c and thinks were fine with the Falcom Samba75 (aka Siemens MC75).

Matthias

On Saturday 27 October 2007 07:09, Pete Zaitcev wrote:
> On Tue, 16 Oct 2007 12:09:05 +0200, Matthias Fuchs <[email protected]> wrote:
> 
> > hub.c: new USB device 00:15.0-1, assigned address 2
> > Manufacturer: Siemens AG Wireless Modules
> > Product: MC75
> > ttyACM0: USB ACM device
> > usb.c: USB disconnect on device 00:15.0-1 address 2
> 
> I don't know what it is. There's no usbmon for 2.4, so we cannot just
> compare traces. Try to ramp up the printouts and see after what exact
> command the modem disconnects.
> 
> -- Pete

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel