USB Transceiver & USB Gadget driver doubts

Hi All,

    I have started to write the gadget driver for i.MX21 (CSB535FS
Board). I am writing it based on the OMAP driver present in the
mainline kernel. I have the following doubts:

1. I configured the OTG of i.MX21 as a function only (and not as OTG).
On the hardware side, I dont have an OTG transceiver (I think it comes
with I2C control) but rather the normal USB tranceiver (Fairchild -
USB1T11A). Is this fine?

2. In the driver, I have just implemented the probe of UDC as of now.
I see a method for pullup disable in the OMAP driver. What is this
for? Where is this pull up used? Is this specific for OMAP?

Thanks,
Midhun.

-------------------------------------------------------------------------
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
[email protected]
To unsubscribe, use the last form field at:
https://lists.sourceforge.net/lists/listinfo/linux-usb-devel