Getting this error on a drive I am testing using version 6.2

I looked through the source and the check for !out.out_regs.is_set() that causes this checks for any register values. The print out before it shows proper values are being received.


=== START OF READ SMART DATA SECTION ===

REPORT-IOCTL: Device=sdc Command=SMART STATUS CHECK
Input:   FR=0xda, SC=...., LL=...., LM=0x4f, LH=0xc2, DEV=...., CMD=0xb0
[Duration: 0.029s]
SMART STATUS RETURN: incomplete response, ATA output registers missing
REPORT-IOCTL: Device=sdc Command=SMART STATUS CHECK returned -1 errno=40 [Function not implemented]
SMART overall-health self-assessment test result: PASSED
Warning: This result is based on an Attribute check.

Thanks,

Dave Gregg

________________________________

PLEASE NOTE: The information contained in this electronic mail message is intended only for the use of the designated recipient(s) named above. If the reader of this message is not the intended recipient, you are hereby notified that you have received this message in error and that any review, dissemination, distribution, or copying of this message is strictly prohibited. If you have received this communication in error, please notify the sender by telephone or e-mail (as shown above) immediately and destroy any and all copies of this message in your possession (whether hard copies or electronically stored copies).

------------------------------------------------------------------------------
Managing the Performance of Cloud-Based Applications
Take advantage of what the Cloud has to offer - Avoid Common Pitfalls.
Read the Whitepaper.
http://pubads.g.doubleclick.net/gampad/clk?id=121054471&iu=/4140/ostg.clktrk

_______________________________________________
Smartmontools-support mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/smartmontools-support