Re: Smart and the -i flag?
Joan <[email protected]>
| Newsgroups | gmane.linux.utilities.smartmontools |
|---|---|
| Message-ID | <CAP4s+CENX8DKwc4TMYkby5czSC-NRRqJai2kabAkU26hf4L-tA@mail.gmail.com> |
The current line in my smartd.conf is this (it has been like this since the begin) > /dev/sda -i 167 -H -d ata -m [email protected] -s (S/../.././02|L/../../6/04) The following warning/error was logged by the smartd daemon: > Device: /dev/sda [SAT], Failed SMART usage Attribute: 167 Unknown_Attribute. Also sent via mail: > The following warning/error was logged by the smartd daemon: > > Device: /dev/sda [SAT], Failed SMART usage Attribute: 167 Unknown_Attribute. It seems to me that it's ignoring the flag, but I don't see how to proceed. The whole config (sdd is a remoable external usb) $ cat /etc/smartd.conf | egrep -v "(^$|^#)" /dev/sda -i 167 -H -d ata -m [email protected] -s (S/../.././02|L/../../6/04) /dev/sdb -H -d ata -m [email protected] -s (S/../.././03|L/../../7/04) /dev/sdc -H -d ata -m [email protected] -s (S/../.././02|L/../../6/04) /dev/sdd -H -d sat -T permissive -m [email protected] -s (S/../.././03|L/../../7/04) /dev/sde -H -d ata -m [email protected] -s (S/../.././02|L/../../6/04) /dev/sdf -H -d ata -m [email protected] -s (S/../.././03|L/../../7/04) DEVICESCAN -d removable -n standby -m root -M exec /usr/share/smartmontools/smartd-runner 2014-05-24 21:14 GMT+02:00 Christian Franke <[email protected]>: > Joan wrote: > >> Good morning, I'm trying to ignore an attribute that is triggering errors >> in a sata disc (precisely a Transcend TS8GHSD310 that issues an error for >> attribute 167) >> >> On the smartd.conf manual I can read >> -i ID [ATA only] Ignore device Attribute number ID when >> checking for failure of Usage >> Attributes. ... >> >> >> But according to the init script -i seems to be used for interval checking >> #/etc/init.d/smartd >> if test -n "$SMARTD_CHECK_INTERVAL" -a "$SMARTD_CHECK_INTERVAL" != >> 1800 ; then >> smartd_opts=" -i $SMARTD_CHECK_INTERVAL" >> fi >> >> > Please note the difference between smartd command line options (man > smartd) and smartd.conf directives (man smartd.conf). > > > > I am using smartd 5.41+svn3365-1 from debian squeeze, but the same manual >> is active for 6.2+svn3841-1.2 (on debian testing) >> So my question is, what is the proper way to avoid triggering error for a >> faulty attribute? >> >> > Add "-i ID" to smartd.conf configuration line of this specific device. > > Thanks, > Christian > > ------------------------------------------------------------------------------ Time is money. Stop wasting it! Get your web API in 5 minutes. www.restlet.com/download http://p.sf.net/sfu/restlet _______________________________________________ Smartmontools-support mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/smartmontools-support