Re: smartd and smartctl - SMART status command failure

Christian Franke <Christian.Franke <at> t-online.de> writes:

> 
> Debug output for SMART STATUS CHECK from your 2nd mail suggests that the 
> SAT layer of this (which?) controller's driver or firmware does not 
> properly return ATA output registers in the SCSI sense data. See this 
.
> 
This is a LSI Logic SAS3008 PCI-Express Fusion-MPT SAS-3 controller


> See smartd.conf directives -a -f -p -u -t -R on smartd.conf man 
> page.

Thanks for the help. Appreciate it. 

regards,
Naveen 




------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e