how to figure out if the captive short self-test has finished -

Hi all,

I ran the captive short self-test and it shows up as -

# smartctl --captive -t short /dev/sdb
smartctl 6.6 2016-05-31 r4324 [x86_64-linux-4.6.0-1-amd64] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF OFFLINE IMMEDIATE AND SELF-TEST SECTION ===
Sending command: "Execute SMART Short self-test routine immediately in
captive mode".
Drive command "Execute SMART Short self-test routine immediately in
captive mode" successful.
Testing has begun.
Please wait 1 minutes for test to complete.
Test will complete after Sat Aug 13 18:07:24 2016

Now should I wait for 5 minutes or something to know if the test is completed ?

Is there a way to see the progress of the test to know where it is at ?

-- 
          Regards,
          Shirish Agarwal  शिरीष अग्रवाल
  My quotes in this email licensed under CC 3.0
http://creativecommons.org/licenses/by-nc/3.0/
http://flossexperiences.wordpress.com
EB80 462B 08E1 A0DE A73A  2C2F 9F3D C7A4 E1C4 D2D8

------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity 
planning reports. http://sdm.link/zohodev2dev
_______________________________________________
Smartmontools-support mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/smartmontools-support