Re: Trouble finding bad block on WDC WD1600SB-01KBA0

[email protected] Wed, 11 Jan 2017 10:25:34 -0500
Newsgroups gmane.linux.utilities.smartmontools
Message-ID <[email protected]>
I've also seen the UDMA_CRC_ERROR_COUNT caused by a bad SATA cable. With
only 1, I wouldn't sweat it. The case I remember, the count was in the
hundreds. It stopped climbing after I switched out the cable. The existing
one was noticeably frayed.

> David, I think the UDMA_CRC_ERROR_COUNT is referring to a crc error on the
> data bus.  If that is right then it can be safely ignored; if it is
> recurring I would try and clean and replug the data connections to the
> drive.  Cheers, Bruce
>
>
>
>> On 11 Jan 2017, at 02:15, mathog <[email protected]> wrote:
>>
>> On 10-Jan-2017 02:07, Carlos E. R. wrote:
>>> On 2017-01-10 02:12, mathog wrote:
>>>> Hi,
>>>>
>>>> One system has a WDC WD1600SB-01KBA0 which shows
>>>>
>>>> 197 Current_Pending_Sector  0x0012   200   200   000    Old_age
>>>> Always
>>>>       -       1
>>>> 198 Offline_Uncorrectable   0x0012   200   200   000    Old_age
>>>> Always
>>>>       -       0
>>>> 199 UDMA_CRC_Error_Count    0x000a   200   253   000    Old_age
>>>> Always
>>>>       -       1
>>>
>>>> Is there some other trick to find the thing?
>>>
>>> I run "badblocks" with the intention of locating them, and they
>>> disappeared...
>>
>> Rebooted that node into PLD Rescue CD over the network, ssh'd into it
>> and ran
>>
>>    badblocks -nvs /dev/sda >/tmp/bb.log 2>&1 &
>>
>> somewhere along the line the pending sector cleared, but there was no
>> message
>> giving the block number, and it said there were no errors.  The
>> UDMA_CRC_ERROR_COUNT is still 1.
>>
>> So that worked.
>>
>> Now, for the next time, is there a command one can use
>> while the OS is running and the disk mounted that can do something
>> similar?
>> badblocks -n isn't happy running on mounted disks, and that badblocks
>> command took ~4.5 hours.
>>
>> Thanks,
>>
>> David Mathog
>> [email protected]
>> Manager, Sequence Analysis Facility, Biology Division, Caltech
>>
>> ------------------------------------------------------------------------------
>> Developer Access Program for Intel Xeon Phi Processors
>> Access to Intel Xeon Phi processor-based developer platforms.
>> With one year of Intel Parallel Studio XE.
>> Training and support from Colfax.
>> Order your platform today. http://sdm.link/xeonphi
>> _______________________________________________
>> Smartmontools-support mailing list
>> [email protected]
>> https://lists.sourceforge.net/lists/listinfo/smartmontools-support
>
> --------------------------------------------------------------------
> Bruce Allen, Adjunct Professor of Physics
> Leonard E. Parker Center for Gravitation, Cosmology and Astrophysics
> Physics Department
> University of Wisconsin - Milwaukee
> 3135 N Maryland Ave
> Milwaukee, 53211 USA
> Tel: +1 414-229-4474
> Fax: +1 414-229-5589
> [email protected]
>
>
> ------------------------------------------------------------------------------
> Developer Access Program for Intel Xeon Phi Processors
> Access to Intel Xeon Phi processor-based developer platforms.
> With one year of Intel Parallel Studio XE.
> Training and support from Colfax.
> Order your platform today.
> http://sdm.link/xeonphi_______________________________________________
> Smartmontools-support mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/smartmontools-support
>



------------------------------------------------------------------------------
Developer Access Program for Intel Xeon Phi Processors
Access to Intel Xeon Phi processor-based developer platforms.
With one year of Intel Parallel Studio XE.
Training and support from Colfax.
Order your platform today. http://sdm.link/xeonphi