Using SMARTd to monitor drives

Hi there,

     I've read through the manpage on SMARTD, but clearly I'm too dense 
to grasp it.

     I understand that I can do a devicescan in the smartd.conf file to 
scan for all devices, so I have the following in the smartd.conf

DEVICESCAN -l error -l xerror -s L/../.././(00|06|12|18)

Now as I understand it, this should log errors and extended errors, and 
run a long test at 12AM, 6AM, 12PM and 6PM.

Am I doing this correctly?

T





------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot