Re: libffcall and selinux

 > > Not sure why, but this seems to be my traditional configure:
 > > ./configure CC='gcc -m64' --with-libsigsegv-prefix=/usr/local
 > >   --disable-maintainer-mode --with-debug --with-module=rawsock build-dir
 > 
 > Ouch. Don't install libraries in /usr/local *EVER*. You'll invariably
 > get trapped by a decades-old GCC bug if you do so. /usr/local is ONLY good
 > for executables. Any other --prefix value is OK; only /usr/local is so bad.

And yet that's where the library ends up when I do plain make install
as the directions say.

However, after hg pull retrieves a few new changes I try without
that and it still finds libsigsegv, and now also finds readline too.

But then make still ends with this:

gcc -m64 -I/home/don/hg/clisp/src -I/home/don/hg/clisp/build-dir/gllib -I/home/don/hg/clisp/src/gllib -g -O2 -W -Wswitch -Wcomment -Wpointer-arith -Wreturn-type -Wmissing-declarations -Wimplicit -Wno-sign-compare -Wno-format-nonliteral -Wno-shift-negative-value -fwrapv -fno-strict-aliasing -ggdb -O0 -DDEBUG_OS_ERROR -DDEBUG_SPVW -DDEBUG_BYTECODE -DSAFETY=3 -DENABLE_UNICODE -DDYNAMIC_FFI -DDYNAMIC_MODULES -I. -I. -c ../src/modules.c
if test -d locale; then rm -rf locale; fi
mkdir locale
(cd po && make && make install datarootdir=.. localedir='$(datarootdir)/locale' INSTALL_DATA='ln') || (rm -rf locale ; exit 1)
make[1]: Entering directory '/home/don/hg/clisp/build-dir/po'
make[1]: *** No rule to make target 'sv.gmo', needed by 'all-yes'.  Stop.
make[1]: Leaving directory '/home/don/hg/clisp/build-dir/po'
Makefile:1382: recipe for target 'locale' failed
make: *** [locale] Error 1
[don@localhost build-dir]$ 


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
clisp-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/clisp-devel