Re: Reading pipe from *standard-input*?

And here is finally the error. That I could not solve. That same
program is working if I run it directly, yet if I make memory image,
it is not.

admin-> org2markdown 
  i i i i i i i       ooooo    o        ooooooo   ooooo   ooooo
  I I I I I I I      8     8   8           8     8     o  8    8
  I  \ `+' /  I      8         8           8     8        8    8
   \  `-+-'  /       8         8           8      ooooo   8oooo
    `-__|__-'        8         8           8           8  8
        |            8     o   8           8     o     8  8
  ------+------       ooooo    8oooooo  ooo8ooo   ooooo   8

Welcome to GNU CLISP 2.49+ (2010-07-17) <http://clisp.org/>

Copyright (c) Bruno Haible, Michael Stoll 1992, 1993
Copyright (c) Bruno Haible, Marcus Daniels 1994-1997
Copyright (c) Bruno Haible, Pierpaolo Bernardi, Sam Steingold 1998
Copyright (c) Bruno Haible, Sam Steingold 1999-2000
Copyright (c) Sam Steingold, Bruno Haible 2001-2010

Type :h and hit Enter for context help.

#+TITLE: here
#+TITLE: here

*** - TERPRI: The value of *ERROR-OUTPUT* was not an appropriate stream: #<CLOSED IO SYNONYM-STREAM *TERMINAL-IO*>. It has been
      changed to #<IO SYNONYM-STREAM *TERMINAL-IO*>.

*** - SYSTEM::READ-EVAL-PRINT: The value of *DEBUG-IO* was not an appropriate stream: #<CLOSED IO SYNONYM-STREAM *TERMINAL-IO*>. It
      has been changed to #<IO SYNONYM-STREAM *TERMINAL-IO*>.
The following restarts are available:
ABORT          :R1      Abort debug loop
Break 2 [2]> 
Break 1 [1]> :q

[/sources/gnu/clisp-clisp/src/eval.d:573] reset() found no driver frame (sp=0x7ffec8edfa60-0x7ffec8eda5b0)
Exiting on signal 6
Aborted

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
clisp-list mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/clisp-list