Re: Reading pipe from *standard-input*?

> * Jean Louis <[email protected]> [2017-03-23 18:34:09 +0300]:
>
> [/sources/gnu/clisp-clisp/src/eval.d:573] reset() found no driver frame
> (sp=0x7ffec8edfa60-0x7ffec8eda5b0)
> Exiting on signal 6
> Aborted

I am pretty sure it's the same as https://sourceforge.net/p/clisp/bugs/695/

You need to fix your Lisp bugs, then CLISP images will not crash.

Try your code at the REPL.

-- 
Sam Steingold (http://sds.podval.org/) on darwin Ns 10.3.1504
http://steingoldpsychology.com http://www.childpsy.net http://camera.org
http://mideasttruth.com http://thereligionofpeace.com
The only people who are as good as they think they are are clinically depressed.

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
clisp-list mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/clisp-list