Re: emacs interface to corman

--- In [email protected], John Thingstad > This is a long 
shot but from emacs try M-x toggle-debug-on-error
> Altso look in the *Messages* buffer for an idea.
> I have a feeling you have messed with the inferiour shell 
attributes.

If it was a problem with me messing with emacs configuration 
settings, I would feel better as I would have something I could 
debug; however, this isn't the case. If I start emacs 
with "runemacs.exe -q" , this starts emas without any 
customizations. I then turn on "Enter Debugger on error" from the 
Options menu. Then, I press "M-:" and evaluate the following:

(run-lisp "c:/bin/corman-2.5/clconsole.exe -image c:/bin/corman-
2.5/cormanlisp.img")

This should be the minimum setup to start Corman Lisp in Inferior 
Lisp Mode. After evaluating the run-lisp form, the *messages* buffer 
has the following messages:

Loading inf-lisp...done
#<buffer *inferior-lisp*>

The *inferior-lisp* buffer has the following:

;; Corman Lisp 2.5  Copyright (c) 2003 Corman Technologies. All 
rights reserved.
;; Unlicensed version: For evaluation and personal use only.
;; Some limitations apply.

In the *inferior-lisp* buffer, I can enter ":c 1" and get no result. 
I can also press "C-c C-c" and get no result.

I am stumped! I can't figure out why everybody else seems to be able 
to run Corman Lisp inside of Emacs but it just hangs for me. 

--
Bill Clementson


------------------------ Yahoo! Groups Sponsor ---------------------~-->
Upgrade to 128-Bit SSL Security!
http://us.click.yahoo.com/p7cEmB/s7qGAA/yigFAA/SyjtlB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
[email protected]

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/