Add dll reference to C# project

Hi,

I am attempting to add a reference to the dllsample.dll, which I built
following the instructions in the documentation, to a C# project in VS .Net.
When I browse and select the dllsample.dll file using the add reference
dialog after clicking OK I get the error:

A reference to 'C:\lisp\dll\dllsample.dll could not be added.  This is not a
valid assembly or COM component.  Only assemblies         with  extension
'dll' and COM components can be referenced.  Please make sure that the file
is accessible , and that it is a valid assembly or COM component.

If I try to register the dll using regsvr32 I get the error:

dllsample.dll was loaded, but the DllRegisterServer entry point was not
found.  This file cannot be registered.

I was able to get the example to work (almost, there was a fatal memory
access problem when I ran it)  following the instructions for the VC++ files
in the dllclient directory but because I am completely unfamiliar with VC++
and COM for that matter, I was unable to extend that solution to my
particular task.  All the references that I found the to the Lib command
were related to VC++ and C# seems to want to do things differently.

I suspect (hope) that this problem has an obvious solution.

thanks

Jim




------------------------ Yahoo! Groups Sponsor ---------------------~-->
Get 128 Bit SSL Encryption!
http://us.click.yahoo.com/xaxhjB/hdqFAA/xGHJAA/SyjtlB/TM
---------------------------------------------------------------------~->

To unsubscribe from this group, send an email to:
[email protected]

 

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/