Re: Booting LOS0 Failure

"Burton Samograd" <[email protected]> writes:

I tried building Movitz on a linux system using SBCL 1.0.29.11 and it
worked and ran fine.  I seem to remember that CLISP wouldn't even dump
the image properly in the past without crashing, so I guess there's
still some errors when using it to build movitz.

> Hi,
>
> I've been a bit interested in movitz again lately, so I downloaded the
> git sources and compiled and dumped LOS0 using CLISP 2.48.  This all
> went well, but when I tried to run the image I got the following:
>
> http://imgur.com/A8Iwl
>
> I tried looking through the code to see what happened, but the most I
> could come up with was that maybe *all-process* was empty during the
> call to (LIB::CURRENT-PROCESS).  Other than that I'm stumped.

--
Burton Samograd