Re: bigloo compile error

Hi Mojca,

> I tested again with the default clang on 10.7 and it seems to break
> with the same error. Then I tried to compile with clang-3.3 which
> failed with (known):
> 
> make[9]: Entering directory `/path/to/bigloo4.1a/api/flac/src'
> /opt/local/bin/clang-mp-3.3  -o libbiglooflac_s-4.1a.dylib 
>                  -install_name
> @executable_path/../Frameworks/bigloo/4.1a/libbiglooflac_s-4.1a.dylib
> 
>                  objs/bglflac.o objs/flac.o objs/flac_alsadec.o 
>                   
>                  -dynamiclib -single_module -Wl,-read_only_relocs,suppress 
>                  -lFLAC  -lbigloo_s-4.1a -lbigloogc_fth-4.1a 
>                  -lc -L/path/to/bigloo4.1a/lib/4.1a -L/opt/local/lib   && 
>          if [ "libbiglooflac_s-4.1a.dylib" !=
> "/path/to/bigloo4.1a/lib/4.1a/libbiglooflac_s-4.1a.dylib" ]; then 
>            mv libbiglooflac_s-4.1a.dylib
> /path/to/bigloo4.1a/lib/4.1a/libbiglooflac_s-4.1a.dylib; 
>          fi
> ld: warning: -read_only_relocs cannot be used with x86_64
> Undefined symbols for architecture x86_64:
>   "_bgl_flac_checksum_debug", referenced from:
>       _bgl_read_callback in bglflac.o
>   "_bgl_flac_debug", referenced from:
>       _bgl_read_callback in bglflac.o
>       _bgl_seek_callback in bglflac.o
>       _bgl_tell_callback in bglflac.o
> ld: symbol(s) not found for architecture x86_64
> clang: error: linker command failed with exit code 1 (use -v to see invocation)
> make[9]: *** [shared-install-name] Error 1
> make[9]: Leaving directory `/path/to/bigloo4.1a/api/flac/src'
> make[8]: *** [shared] Error 1
> make[8]: Leaving directory `/path/to/bigloo4.
Fixed. Fairly easy as this was just dead code!

I will prepare a new tarball and check it against my local clang. I will upload
it when it will pass the whole test suite successfully.

-- 
Manuel