RE: Detecting failures in ms-Access

In MS Access, sending an email using blat should be done within a function.
The return value of that function can tell whether email was sent
successfully or nit.

  -----Original Message-----
  From: [email protected] [mailto:[email protected]]On Behalf Of Tim
Musson
  Sent: Friday, May 02, 2014 3:14 PM
  To: [email protected]
  Subject: Re: [blat] Detecting failures in ms-Access



  Hey David,

  On Thursday, May 1, 2014 at 11:33:49 PM you wrote

  dyc> How do i detect send failures from within ms-access?

  I don't use MS Access. I would expect you would check return codes and
  the Blat log file. That is how I would do it in a Batch file.

  I know there is an example of how to use Blat with Access here:
  http://www.blat.net/examples/

  There is also a Return/Exit Code link on that same page.

  --
  Tim Musson
  Flying with The Bat! eMail v5.8.2
  Printed on 100% recycled electrons.