| Newsgroups |
gmane.mail.blat |
| Message-ID |
<[email protected]> |
> *From:* "'Jack Weaver' [email protected] [blat]"
> <[email protected]>
> *To:* [email protected]
> *Date:* Sun, 10 Aug 2014 08:29:41 -0400
>
> --Original Message Text---
> From: 'Jack Weaver' [email protected] [blat]
> Date: Sat, 09 Aug 2014 12:14:00 -0400
>
> --Original Message Text---
> From: 'John K.Eason' [email protected] [blat]
> Date: Sat, 9 Aug 2014 15:36 +0100 (BST)
>
> > *From:* "'Jack Weaver' [email protected] [blat]"
> > <[email protected]>
> > *To:* [email protected]
> > *Date:* Sat, 09 Aug 2014 07:35:42 -0400
> >
> > I've been using Blat 312 for three months now and Iv'e have been
> > very happy with the results, thanks for great product
> >
> >
> > There is, however, one minor thing that I can't figure out from
> > the
> > documentation: I would like to be able to address the recipients
> > of my e-mails by name and e-mail address (W. T. Door
> > [email protected])
> > rather than by just their e-mail address alone. -to doesn't seen
> > to
> > allow this but I was wondering if -tf will and, if so, what is the
> > required format of the entries in the file?
> >
> >
> > Thanks for you help...
>
>
> I've not used the format in a list of names in a file, but have a
> look
> at http://www.blat.net/examples/to-cc-bcc.html for the format to
> use on
> the command line.
>
>
> Regards
> John
>
>
> Thanks, I'll give that a try.
>
>
> Later: Thanks again, that worked just as advertised both ways,
> directly from the command line and indirectly from a file.
Excellent! There are quite a few blat tips and tricks here:
http://www.blat.net/examples/index.html
Regards
John