RE: BLAT Timing out, Error: Server refused connection.

Yes that's correct . It won't start even tho it's set to Automatic in Services . When I manually start the service it works. Ideas? 

Sent from Yahoo Mail on Android 
 
  On Thu, Nov 3, 2016 at 12:53 AM, 'Skand Bhargava' [email protected] [blat]<[email protected]> wrote:       

You mean you had rebooted computer but stunnel did not start automatically though it is configured to do so? 
Regards,

For Softools Middle East, A Dubai Based Company
 
Skand Bhargava
TAS2000 & HR2020: Serious Attendance & HR Systems
PO Box 14959, Dubai
Tel:  +971 4 2680533, Mob: +971 50 6340258 

 -----Original Message-----
From: [email protected] [mailto:[email protected]]
Sent: Thursday, November 03, 2016 12:58 AM
To: [email protected]
Subject: Re: [blat] BLAT Timing out, Error: Server refused connection.

   
 
 Stunnel wasn't running even tho it's set to start automatically!!!!                Is there a program with SMTP protocol listening on a port at which blat is sending on same computer?    -----Original Message-----
From: [email protected] [mailto:[email protected]]
Sent: Wednesday, November 02, 2016 8:29 PM
To: [email protected]
Subject: [blat] BLAT Timing out, Error: Server refused connection.

 
    2016.11.02 09:22:29 (Wed)------------Start of Session-----------------
 Blat v3.2.4 (build : Feb 24 2015 21:29:33) 32-bit Windows, Full, Unicode superDebug: init_winsock(), WSASt artup() returned 0 (NO_ERROR) superDebug: Attempting to connect to ip address 127.0.0.1 superDebug: ::connect() returned error 10061, retry count remaining is 0 superDebug: Connection returned error 183 unexpected error 183 (?) f rom winsock Error: Can't connect to server (timed out if winsock.dll error 10060)  2016.11.02 09:22:30 (Wed)-------------End of Session------------------ 
 
 
 Any help would be appreci ated. Thanks! 
 Chris