AW: reroute one specific domain

Hallo Marcel,
hast du so etwas probiert:
Relay: domain.ch = domain.ch@[ip.ad.res.se]

Wenns nur für smtp ist, kann man am Schluss noch .smtp hinzufügen - aber normalerweise ist das nicht nötig.

Grüsse
Ralf



Ralf Zenklusen
Leiter Internet
Dipl. El. Ing. HTL

BAR Informatik AG
Gliserallee 16
CH-3902 Brig-Glis
Schweiz

Tel:  +41 27 922 48 48
Fax:  +41 27 922 48 49
www.barinformatik.ch
www.rhone.ch
www.colobrig.ch
www.finishweb.ch





-----Ursprüngliche Nachricht-----
Von: CommuniGate Pro Discussions [mailto:[email protected]] Im Auftrag von Marcel Hochuli
Gesendet: Montag, 26. Oktober 2015 11:30
An: CommuniGate Pro Discussions
Betreff: Re: reroute one specific domain

Hi

I tried my first option (see below) and it didn't work. It was sent to the forwarding server as all other E-Mails and this one (an IronPort Blocker) didn't understand the domain. So it bounced back to me.

Is it possible to get around the setting "Forward to" on page <https://mail.domain.dom:9010/Master/Settings/SMTPSend.html?> via the Router Module??



Marcel


+---
mailto:[email protected]
otherto:[email protected]
_______________________________________



> Am 21.10.2015 um 17:18 schrieb Marcel Hochuli <[email protected]>:
> 
> Hi
> 
> We need to reroute one domain internally via VPN tunnel instead of via 
> the internet
> 
> Is a router record with IP address in brackes sufficient or does it need a ._via at the end. If both is OK, what is the difference?
> 
> 
> company.com = [192.168.10.11]
> 
> company.com = [192.168.10.11]._via
> 
> 
> Thanks
> Marcel
> 
> +---
> mailto:[email protected]
> otherto:[email protected]
> _______________________________________
> 
> 
> 
> 
> #############################################################
> This message is sent to you because you are subscribed to  the mailing 
> list <[email protected]>.
> To unsubscribe, E-mail to: <[email protected]> To switch 
> to the DIGEST mode, E-mail to <[email protected]>
> To switch to the INDEX mode, E-mail to 
> <[email protected]> Send administrative queries to  
> <[email protected]>


#############################################################
This message is sent to you because you are subscribed to
  the mailing list <[email protected]>.
To unsubscribe, E-mail to: <[email protected]> To switch to the DIGEST mode, E-mail to <[email protected]>
To switch to the INDEX mode, E-mail to <[email protected]> Send administrative queries to  <[email protected]>




#############################################################
This message is sent to you because you are subscribed to
  the mailing list <[email protected]>.
To unsubscribe, E-mail to: <[email protected]>
To switch to the DIGEST mode, E-mail to <[email protected]>
To switch to the INDEX mode, E-mail to <[email protected]>
Send administrative queries to  <[email protected]>