Re: Routing all but one address
Palvelin Postmaster <[email protected]>
| Newsgroups | gmane.mail.cgatepro.general |
|---|---|
| Message-ID | <[email protected]> |
Humm…this doesn’t seem to work R.M:<[email protected]> = [email protected] R:M:<*@domain.dom> = [email protected] [email protected] goes to loop with the above rules. All other addresses get routed to [email protected] properly. > On 27.11.2015, at 16:58, Nicolas Hatier <[email protected]> wrote: > > > Router rules are applied in order, so yes, just put your exception BEFORE the global rule, and make good use of the .here specifier if needed. > > I guess that would look like this (not tested): > > R:M:<[email protected]> = [email protected] > R:M:<[email protected]> = [email protected] > > Nicolas > > > On 2015-11-27 09:53, Palvelin Postmaster wrote: >> Is it possibe to use the Router to route all incoming email of a specific domain to a specific mailbox EXCEPT one email address? For example >> >> [email protected] is routed to [email protected] >> except >> [email protected] is routed to [email protected] >> > > > ############################################################# > This message is sent to you because you are subscribed to > the mailing list <[email protected]>. > To unsubscribe, E-mail to: <[email protected]> > To switch to the DIGEST mode, E-mail to <[email protected]> > To switch to the INDEX mode, E-mail to <[email protected]> > Send administrative queries to <[email protected]> ############################################################# This message is sent to you because you are subscribed to the mailing list <[email protected]>. To unsubscribe, E-mail to: <[email protected]> To switch to the DIGEST mode, E-mail to <[email protected]> To switch to the INDEX mode, E-mail to <[email protected]> Send administrative queries to <[email protected]>