Re: DMARC plugin not working

The DKIM script doesn't need an external source for validating DKIM, it uses a Perl module for that. So it only needs the SPF header from CGP, so I don't think the priority for the rule matters. But you can always check 1 and 9 to be sure.

As for troubleshooting, set the helper to all info and see what happens. If nothing happens you probably have an error in your global rule.

Also check that it starts and can find all needed modules, like so:

[cgatepro@baphomet /var/CommuniGate]$ CGPDMARC/CGPDMARC 
* DMARC.pl started.
* reports daemon started
* composing report for darkness-reigns.net
1 QUIT
1 OK
* stopping DMARC.pl
* reports daemon stopped

If that's all OK, mail us the output of

# cat 2016-10-02.log |grep "R(DMARC"

Good luck!

-- 
Regards,
   Terrence Koeman, PhD/MTh/BPsy
      Darkness Reigns (Holding) B.V.

Please quote relevant replies.


> -----Original Message-----
> From: CommuniGate Pro Discussions [mailto:[email protected]] On
> Behalf Of Agi Subagio
> Sent: Sunday, October 2, 2016 5:57 AM
> To: CommuniGate Pro Discussions <[email protected]>
> Subject: DMARC plugin not working
> 
> I'm testing DMARC plugin with CGP 6.1.8 on CentOS 6.8. Check SPF addheader
> and DKIM_verify plugin are working fine. I use lower priority for DMARC_scan
> after DKIM_verify, but DMARC didn't add any header for all incoming email.
> What should I check?


#############################################################
This message is sent to you because you are subscribed to
  the mailing list <[email protected]>.
To unsubscribe, E-mail to: <[email protected]>
To switch to the DIGEST mode, E-mail to <[email protected]>
To switch to the INDEX mode, E-mail to <[email protected]>
Send administrative queries to  <[email protected]>