Mailman sa-exim Question

   Hi 

   Sorry to be a pest again.

   I have a question concerning mailman and sa-exim.

   My mailman configuration uses: 

http://www.daa.com.au/~james/articles/mailman-spamassassin/

   And the following happened:

2003-08-08 07:20:35 19l5IQ-0002Me-S4 SA: Debug: SAEximRunCond expand
returned: '1'
2003-08-08 07:20:35 19l5IQ-0002Me-S4 SA: Debug: check succeeded, running
spamc
2003-08-08 07:20:39 19l5IQ-0002Me-S4 SA: Debug: SAEximRejCond expand
returned: '1'
2003-08-08 07:20:39 19l5IQ-0002Me-S4 SA: Debug: SAteergrubecond expand
returned: '1'
2003-08-08 07:20:39 19l5IQ-0002Me-S4 SA: Debug: Writing message to
/var/spool/exim/SAteergrube/new/[email protected].
2o.oxd
2003-08-08 07:35:40 19l5IQ-0002Me-S4 SA: Action: teergrubed sender until
full configured duration of 900 secs (hits=9.9 requir
ed=4.3 trigger=5.0)
2003-08-08 07:35:40 19l5IQ-0002Me-S4 temporarily rejected by
local_scan(): "Please try again later"


   Which of course is fine.

   The problem is that the message was forwarded to mailman and the
spamassassin patch to mailman kicked in and had the message marked for
approval.

   Is there a way to configure sa-exim to _not_ do this? If the message
is teergrubed then I'd like the message dropped just as it does for a
message destined to a regular user.

   Thanks

   J



-- 
Justin F. Knotzke
[email protected]
http://www.shampoo.ca