Re: sieve ports: 2000 and 4190
Anton Shilov via Info-cyrus <[email protected]>
| Newsgroups | gmane.mail.imap.cyrus |
|---|---|
| Message-ID | <[email protected]> |
Hi Sergey,
I think - yes. You can use something like this:
================
cyrus.conf
SERVICES {
...
sieve2000 cmd="timsieved" listen="2000" proto=tcp4 prefork=0
sieve4190 cmd="timsieved" listen="4190" proto=tcp4 prefork=0
...
}
===============
or use tcp-balanser soft which listening to client side two ports 2000 and 4190 and than pass connect to timsieved standatr port 4190 in cyrus enviroment.
>Пятница, 1 сентября 2017, 13:47 +07:00 от Sergey <[email protected]>:
>
>Hello.
>
>I seen what RFC 5804 recommend to use port 4190.
>Is it possible to run timsieved on 2000 and 4190 both ?
>
>--
>Regards, Sergey
>----
>Cyrus Home Page: http://www.cyrusimap.org/
>List Archives/Info: http://lists.andrew.cmu.edu/pipermail/info-cyrus/
>To Unsubscribe:
>https://lists.andrew.cmu.edu/mailman/listinfo/info-cyrus
----
Cyrus Home Page: http://www.cyrusimap.org/
List Archives/Info: http://lists.andrew.cmu.edu/pipermail/info-cyrus/
To Unsubscribe:
https://lists.andrew.cmu.edu/mailman/listinfo/info-cyrus