Re: Preventing Plain Auth
Vladislav Kurz via dovecot <[email protected]>
| Newsgroups | gmane.mail.imap.dovecot |
|---|---|
| Message-ID | <[email protected]> |
Dne 06. 03. 26 v 0:04 Steve Litt via dovecot napsal(a):
> Hi all,
>
> I put auth_allow_cleartext = no in my 2.4.2 dovecot.conf, but my
> Claws-Mail client can still access it, even though there are no key
> files. I tried putting this setting in several different places: Didn't
> prevent plain access. I tried switching from 127.0.0.1 to 10.0.2.15,
> same problem.
In my experience (dovecot 2.3.13 with disable_plaintext_auth = yes), it
allowed plaintext on loopback interface, but not when accessing
remotely. This is imho good, so that local webmail can access imap at
localhost without wasting cpu cycles on ecnryption.
I have the option near the top of the file, not in any block. E.g. right
after listen.
--
Best regards
Vladislav Kurz
_______________________________________________
dovecot mailing list -- [email protected]
To unsubscribe send an email to [email protected]