incomplete deliveries
Darrell Burkey <[email protected]>
| Newsgroups | gmane.mail.majordomo.general |
|---|---|
| Message-ID | <[email protected]> |
We've been running sendmail 8.12.9 with majordomo 1.95 on a Sun box (Solaris 7) without issue for some time. We have quite a few lists with up to 5,000 addresses. We use bulk_mailer to inject these in to sendmail. While I doubt this is a majordomo specific issue I'm sure there are some sendmail gurus hanging around here and I'm running out of ideas so here goes. We recently upgraded sendmail to 8.13.6 which I compiled from source. Now we find that when majordomo lists are executed, bulk_mail doesn't complete the entire run. We've run it in debug mode and it processes everything fine but just stops at a random point with no errors and leaving hundreds of messages not injected to sendmail. I suspect some kind of timing error with sendmail but as far as I can see the new version was compiled virtually the same as the old version. If this rings a bell with anyone or if you have suggestions on tests I can do to track down what is causing this, I would be most grateful. Cheers. -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Darrell Burkey UNIX Systems Administrator College of Asia & the Pacific Australian National University Ph: (02) 6125 4160