Re: Get recipients

On 04/11/2017 10:09 AM, Stagiair 2. Cisa wrote:
> I've checked on capitals and this was fine. It looked like a non-existing or empty array.
> 
> After some testing I've found out the array actually really exists and I can access it.
> The only problem is that the values (the different recipients addresses) are empty in the array.
> 
> When I send to 3 recipients, it actually sees that there are 3 recipients but instead of giving me the addresses it returns an empty string.
> So I think the array is like
> 	@Recipients = ("", "", "");
> 
> Same for 2 recipients, it sees there are 2 but returns empty strings.
> 	@Recipients = ("", "");
> 
> I tried using foreach to get the recipients out of the array.
> I've also tried using #Recipients[i], but no success either.

Please keep your replies on-list, not just to me individually.

I don't know why you'd be seeing that. I use @Recipients extensively in
my filter and it works fine.

I'd probably try sticking some syslog calls in mimedefang.pl (the actual
mimedefang code) where it sets @Recipients. Then trace from there.

-- 
Richard
_______________________________________________
NOTE: If there is a disclaimer or other legal boilerplate in the above
message, it is NULL AND VOID.  You may ignore it.

Visit http://www.mimedefang.org and http://www.roaringpenguin.com
MIMEDefang mailing list [email protected]
http://lists.roaringpenguin.com/mailman/listinfo/mimedefang