Re: Reload doesnt work

How can i check for the use of that multiplexor?

Med venlig hilsen
Thomas Kristensen

Storhaven 12 - 7100 Vejle
Tlf: 75 72 54 99 - Fax: 75 72 65 33
E-mail: [email protected]

-----Oprindelig meddelelse-----
Fra: MIMEDefang [mailto:[email protected]] På vegne af Bill Cole
Sendt: 3. oktober 2017 09:19
Til: [email protected]
Emne: Re: [Mimedefang] Reload doesnt work

On 2 Oct 2017, at 4:03, Thomas Kristensen wrote:

> Hey
>
> I got this problem that the reload function doesnt reload my rules.
>
> Nothings happens when i use the reload, i have to stop mimedefang and 
> start it again to use the changes made in mimedefang-filter.

This is platform-specific. If your platform uses systemd, the command "systemctl reload mimedefang"  doesn't reload the mimedefang-filter, it only reloads the systemd definition of the mimedefang service, which effectively does nothing. To get your system to reload the mimedefang-filter, use the md-mx-ctrl tool:

    md-mx-ctrl reread

OR if you are not using the mimedefang-multiplexor (which I think everyone should...) you can keep using the systemctl stop and start functions while screaming curses at the abomination that is systemd and its deeply ignorant design.
_______________________________________________
NOTE: If there is a disclaimer or other legal boilerplate in the above message, it is NULL AND VOID.  You may ignore it.

Visit http://www.mimedefang.org and http://www.roaringpenguin.com MIMEDefang mailing list [email protected]
http://lists.roaringpenguin.com/mailman/listinfo/mimedefang

_______________________________________________
NOTE: If there is a disclaimer or other legal boilerplate in the above
message, it is NULL AND VOID.  You may ignore it.

Visit http://www.mimedefang.org and http://www.roaringpenguin.com
MIMEDefang mailing list [email protected]
http://lists.roaringpenguin.com/mailman/listinfo/mimedefang