Re: message-Id has localhost

Ken Hornstein <[email protected]> wrote:
    > Ralph has already noted that this message still has those bytes at the
    > end, but I think there was a mh-e error as this message wasn't even
    > clearsigned.  Instead this was at the top:

    >> <#secure method=pgp mode=sign>

Yeah, that happens when I futz with the mh-e instructions too many times;
they wind up getting ignored.

    > As a note I'm wondering what those bytes even are; they aren't valid
    > UTF-8.

So the message which I replied to Ralph, I just sent with:
   send -draftfolder +drafts -draftmessage 9

(it was message 9 in drafts)

And it *did not* have the training stuff.
I also didn't append my signature, and there may be some other mh-e things
that didn't occur.  I looked at my .signature.* files, and I don't see the
garbage there.  It must be something inside emacs, I think.

I should replace send with something else and see.

--
]               Never tell me the odds!                 | ipv6 mesh networks [
]   Michael Richardson, Sandelman Software Works        |    IoT architect   [
]     [email protected]  http://www.sandelman.ca/        |   ruby on rails    [

-----BEGIN PGP SIGNATURE-----

iQFFBAEBCgAvFiEEbsyLEzg/qUTA43uogItw+93Q3WUFAmWRsygRHG1jckBzYW5k
ZWxtYW4uY2EACgkQgItw+93Q3WWYcwf7BCMuYIBex2e7DKahBqIcZoPEQ8NrfiDI
j2idRnLQ9k4Eng20+Ciay0xHr7djlLjP16IacJn0AzeO62CXKhp3LORGp7B/l+pV
ImW4BiU8xXclMQMQ3poOkDc+qu7D1HZhMku8fXUY0GBTu14EvWTnVdvvGgMoaAgZ
WyhkkjxRMc89kqukv4AiMQxWFee6Pd5IJqxJO+CrcUlPLRJHeltOhwmWikCcX07N
tACpKuR07wzWdmTgVSRRPEsreb1hXQq6aeipOJXdVJBbLdhgyO2IFtRVEnaUWmBm
FIZHGbUxcWdHNEkeCgJqrH3/W2xObAGk4+fbZumRuUK902jBpn8Yog==
=YAoQ
-----END PGP SIGNATURE-----