Re: Setting up NMH with Fastmail

Ken Hornstein <[email protected]> wrote:
    >> (tls-decrypted) <= 250 AUTH PLAIN LOGIN XOAUTH2 OAUTHBEARER
    >> SASL mechanisms supported by server: PLAIN LOGIN XOAUTH2 OAUTHBEARER
    >> No SASL mech selected, will pick the best mech supported by SASL library
    >> Client supported SASL mechanisms: SCRAM-SHA-512 SCRAM-SHA-384 SCRAM-SHA-256 SCRAM-SHA-224 SCRAM-SHA-1 DIGEST-MD5 EXTERNAL CRAM-MD5 NTLM LOGIN PLAIN ANONYMOUS
    >> SASL security layers disabled due to the use of TLS
    >> Chosen sasl mechanism: LOGIN

    > The difference between this output and Diego's is that Diego's doesn't show
    > client support for PLAIN.  A little odd that it picked LOGIN as a mechanism,
    > but fine, whatever.  I hope the SASL log patch I sent him will help.

I usually compile nmh from source code, because fixes/patches/etc.
Maybe the debian package is compiled without the right sasl-dev libraries included.
Looking into the source code, however, I see:

Build-Depends: debhelper (>= 12.0.0), dh-strip-nondeterminism, libncurses5-dev, liblockfile-dev (>= 1.01), libsasl2-dev, libdb-dev, flex, libfl-dev, libssl-dev, libcurl4-openssl-dev, libreadline-dev, libsasl2-modules

I could try again with the nmh package....
... apt-get install nmh.  Got me 1.8-RC2.

obiwan-[~](3.3.8) mcr 10022 %/usr/bin/mh/send -snoop drafts/54

but, I didn't get any output from -snoop.
I was asked twice about upgraded to 1.8-RC2...
Confused.

--
]               Never tell me the odds!                 | ipv6 mesh networks [
]   Michael Richardson, Sandelman Software Works        |    IoT architect   [
]     [email protected]  http://www.sandelman.ca/        |   ruby on rails    [