Compiling

Hi,

I have installed and tested Perdition 1.17 on CentOS 5.4 fine using the 
1.17 RPM's - but now I'm trying to install 1.18 via source as there is 
no RPM for that yet.  I'm getting the following error when trying to 
compile Venessa logger:

# make
make  all-recursive
make[1]: Entering directory `/root/perdition/vanessa_logger-0.0.8'
Making all in libvanessa_logger
make[2]: Entering directory 
`/root/perdition/vanessa_logger-0.0.8/libvanessa_logger'
if /bin/sh ../libtool --tag=CC --mode=compile gcc -DHAVE_CONFIG_H -I. 
-I. -I..     -g -O2 -MT vanessa_logger.lo -MD -MP -MF 
".deps/vanessa_logger.Tpo" -c -o vanessa_logger.lo vanessa_logger.c; \
        then mv -f ".deps/vanessa_logger.Tpo" 
".deps/vanessa_logger.Plo"; else rm -f ".deps/vanessa_logger.Tpo"; exit 
1; fi
../libtool: line 466: CDPATH: command not found
../libtool: line 1144: func_opt_split: command not found

libtool: Version mismatch error.  This is libtool 2.2.6 Debian-2.2.6a-4, 
but the
libtool: definition of this LT_INIT comes from an older release.
libtool: You should recreate aclocal.m4 with macros from libtool 2.2.6 
Debian-2.2.6a-4
libtool: and run autoconf again.
make[2]: *** [vanessa_logger.lo] Error 1
make[2]: Leaving directory 
`/root/perdition/vanessa_logger-0.0.8/libvanessa_logger'
make[1]: *** [all-recursive] Error 1
make[1]: Leaving directory `/root/perdition/vanessa_logger-0.0.8'
make: *** [all] Error 2

I'm not sure what I should be recreating with what. :P  Its a standard 
CentOS 5.4 install and has libtool-1.5.22-6.1 installed.  I tried 
compiling and installing libtool 2.2.6 but that didnt fix the issue.

Any pointers appreciated.

Thanks.

Jim.
______________________________________________
Perdition-users mailing list
[email protected]
http://lists.vergenet.net/listinfo/perdition-users